专业的解决方案助你成功 Professional Solutions For Success
首页 > 弹性地材辅材系统 > 自流平系列 > HENRY 542

产品图片和视频

HENRY 542 HENRY542自流平,采用特种水泥、精细骨料、聚合物喷雾干粉树脂及其他水泥添加剂组成。产品具有良好的流动性,能够快速找平地面,可应用于泵送设备施工。快硬早强,24小时后可进行下一道工序,缩短工期;可直接在完成地面铺贴瓷砖、木地板、地毯、PVC地板等地面材料。

特点:

● 施工厚度单次可达2-4mm;

● 施工便捷,快速找平;

● 强度高,低收缩。

 

适用基层:

● 适用于仓储、医疗、教育、家庭、商业公共场所等地面工程的基层找平。

 

基层处理:

● 基层必须干燥、坚实、可承重、无尘、无妨碍粘结杂物。为保证自流平表面强度和附着力,建议使用HENRY水性界面剂或HENRY环氧界面剂对基层进行处理。

 

技术参数:

● 存储期:         6个月

● 混合比:         粉(25Kg):水(6L)

● 流动度:         ≥130mm

● 可施工时间:   ≥20min

● 可铺地板所需时间: ≥24h

● 可上人时间:           ≥6h

● 抗压强度(28天后):≥22(MPa)

● 抗折强度(28天后:   ≥5(MPa)

● 可通行时间:   ≥6h

● 施工温度:      5~30℃

 

参考用量:

● HENRY542自流平的用量约为1.5kg/m2·1mm(具体用量由施工厚度以及基面的实际条件决定)

 

施工说明:

基层清理干净后,根据基层情况选用合适的界面剂。

在一容器中倒入6L清水,然后慢慢加入一包25Kg的自流平,用搅拌机搅拌3-5分钟至均匀无团的浆状,将混合料倒出,均匀地铺开,用抹刀布展均匀至所需的厚度,刚施工好的混合料要防止受阳光直射和强风吹拂,混合料须在20分钟内完成施工。也可以采用输送能力(20-40公升/分钟)的泵输送浆体进行施工。

初凝前需使用特制消泡辊滚压,以排除浆体内空气。

※对所铺设地板不承担责任。如有疑问,请进行检测和试铺设。注意遵守亨历产品说明书要求。

 

包装与储存:

●25Kg复合纸袋包装。本品必须存放于室内,注意防潮、防止冰冻、暴晒。托盘上堆放不超过8层,以免结块。通常条件下,保质期为6个月。

 

安全防护:

● 由于本品含水泥,会与水反应产生强碱性,避免与皮肤、眼睛接触。一旦接触,立即用大量清水冲洗;如果皮肤或眼睛受到伤害,立即就医。本品完全硬化后不会产生对身体、环境有影响的物质。

 

Features:

Excellent Grab;

Application thickness up to 2-4mm;

Easy to application,Fast leveling;

High strength,Low shrinkage.

 

Description:

HENRY 542 self-leveling, with the special cement, fine aggregate, polymer resin and other additives of cement powder spray, the product has good mobility , can fast automatic leveling the ground, a construction thickness of up to 2-4mm at room temperature, can walk after 6 hours, 24 hours for the next process, shorten the construction period, can be directly in the ground paving tile, wood flooring, carpet, flooring and other materials to provide all kinds of elastic ground leveling intact, solid ideal base, non-toxic and harmless, green environmental protection products. 

 

Applicable Substrate:

Apply to warehouses, hospitals, operation room, family, office and other ground engineering level leveling. 

 

Substrate Preparation:

The base must be dry, firm, load-bearing, dust-free, and free from impurities. In order to ensure the self-leveling surface strength and adhesion, HENRY is recommend for absorbent /non-absorbent substrate. 

 

Application:

1.After cleaning up the grassroots, should choose the appropriate primer.

2.In a container of water poured into the 6L, then slowly add a bag of 25Kg self leveling, stirring for 3-5 minutes to uniform group slurry mixer, the mixture is poured, evenly spread, with a spatula to exhibit uniform required thickness, good construction mixture just to prevent direct sunlight by the sun and the wind blowing, mixture construction must be completed in 20 minutes. The slurry can be conveyed with a pump capacity (20-40 L/min).

3.Before the initial coagulation, the use of special defoaming roll roll to exclude the air, to ensure uniform thickness. 

 

Technical Data:

Storage period:       6 months

Fluidity:                   ≥130mm

Application time:     ≥20min

Compressive strength (28 days later): ≥22(MPa)

Flexural strength (28 days later):          ≥5(MPa)

Construction temperature:                   5~30℃

Mixing ratio:      Powder (25Kg): water (6L)

 

Reference Dosage: 

The coverage of HENRY 542 self-leveling is about 1.5kg /m2·1mm, the specific amount is determined by the actual conditions and the thickness of the construction base.

 

Matters Needing Attention:

As this product contains cement, it reacts with water to produce strong alkaline, and avoid contact with skin and eyes. Once in contact, flush immediately with water. If skin or eye is injured, seek medical attention immediately. This product is completely hardened and will not produce any material that affects the body or the environment. 

 

Packaging And Storage:

25Kg/bag. This product must be stored in the room. No more than 8 layers on pallets, shelf life is 6 months.